Board motor is to be used on the boat, omit the molding on the transom and cut the gunwale moldings to fit flush with the back of the transom. then cut the plywood fore-deck to size and nail it to the gunwales and deck beams as shown. next the boat is turned over and 1 x 2-in. oak runners are attached to the bottom, as in figs. 3 and 4,. This is a typical jon boat. i bought my plans from one of the big companies that sell plans for these boats. today i was checking the scarf joint that i glued up and the 16 foot long board was so floppy i was afraid the scarf joint was going to break so i added a block to the inside of the panel. jon boat build looking good, donald.. The first gf was going to be a plain jon boat but while researching some old designs, we discovered the lines of a classic garvey listed as a duck boat in the plans catalog of the smithsonian..
Despite a common misconception, a pretty boat is not more difficult to build than an ugly box. this boat will do all what jon boats do but look much better and have a higher resale value. it can also be used as a duck boat. we designed the gf14 first and with a small change in the building method, we were able to increase the length to 16'.. Jon boat 16 by bateau.com [gf16] a simple and economical 16' flat bottom garvey: jon boat, duck boat 16' 4.85 m: 5' 2" 1.58 m - 15 phantom 16 by bateau.com a flats fisherman dream. it is used by professional fishing guides in florida! 16' 4.85 m. Re: 12ft or 16ft jon boat plans free or cheap hi, thanks for the reply. the one i have chosen has constant width and beam for 3/4 of it length, so removing 3 ft from the end won't make any difference..
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.